The reason for the poor adsorption force of the CNC Router has been found

There are many CNC router manufacturers in the market now, but the machining level of these manufacturers is uneven, which leads to differences in the quality of the machined machines. The quality of the machine is not very good, which leads to the poor adsorption force of the machine table. It is easy to run the board during the processing of the plate, and the machining accuracy is not accurate. So do you know what is the reason for the poor adsorption force of the CNC router ? How much do you know about this? Next, the professional router manufacturer Blue Elephant CNC will give you a detailed summary, hoping to help you.

1. Whether the tape is flat: the laying should be flat, not uneven. After the tape is applied, the surface should be higher than the countertop area.

2. Adsorption control: try to process as many materials as needed, open as many partitions as possible, and close those not in use in time.

3. Check the tightness: listen to the sound of air leakage at the bottom of the machine.

4. The cleanliness of the countertop: keep the countertop clean and flat, and impurities will also affect the adsorption effect.

The main reasons for the poor suction of the suction table of the CNC router are whether the tape is flat, the adsorption control, the tightness of the equipment, the cleanliness of the table and many other factors. Therefore, it is recommended that you do a good job in the overhaul and maintenance of the equipment before the equipment is running. If you want to know more about the production skills of the router equipment, please pay more attention to the updates of our website!

Leave a Reply

Your email address will not be published. Required fields are marked *