In the process of using the CNC Router, we will encounter various problems, so that small problems will become big problems, but when we encounter problems, we need to judge these problems, then everyone knows What are the common faults, fault judgment methods and solutions of the Router? How much do you know about it? Next, Blue Elephant CNC will give you a detailed summary, hoping to help you.
1. Handling overruns
Reason: This situation is usually caused by the value of “Physical Coordinate Position” and “Substitute Machining File Size” of the machining zero point exceeding the maximum or minimum value set by “Soft Limit”.
Judgment method: After the user defines the machining zero point, the machining starts, and the X-axis or Y-axis exceeds the limit in a certain direction.
Solution: re-select the appropriate machining zero point.
2. Handling abnormal interrupts
Reason: The limit area set by the user is smaller than the actual processing area of the machine tool.
Judgment method: The system can start processing normally, and abnormal interruption occurs after processing for a period of time.
Solution: The restricted area is larger than the actual processing area of the machine tool.
3. Power outage
Cause: Voltage fluctuations.
Judgment method: the screen prompts normal, but pressing any key when the value stops changing has no effect; the screen prompts “entering the power-off protection state, it may be that your power-off protection does not match the voltage.” Panic occurs when manual movement; manual operation , the screen displays “entering the power-off protection state, it may be that your power-off protection does not match the voltage”; the prompt screen displays the current operation status, and pressing any key is invalid.
Solution: This situation usually occurs when the voltage fluctuates, similar to the situation of power failure protection. Only when the voltage fluctuation is small, there will be a prompt on the screen, but when the voltage fluctuation is too large, the screen cannot be displayed due to the reset circuit of the power management chip in the control card. After adjusting the working voltage of the control card to 5.3V, the above situation can basically be solved
In the process of CNC woodworking Router, the above problems will inevitably occur. In order to avoid better maintenance of the working performance of the Router, we should maintain good use and maintenance habits.
In the process of using CNC Router processing, we cannot avoid the problems in the above content, but in order to better maintain the working performance of the Router, we can maintain good use and maintenance habits, through regular inspection and maintenance , so that problems can be found in time and solved in time to avoid problems.
